Description

2 Necklaces with Miyuki Seedbeads and Tila

This nice set you can combine in many ways with different colors. This set consists of two necklaces that you can wear together by the length difference, but also separately are very nice.

Used Materials:

Chain with Coin Charm

Miyuki Tila 5x5mm Opaque Picasso Turquoise Blue
Miyuki Delica's 11/0 Fancy Lined Willow
Miyuki Seed Beads 11/0 Duracoat Galvanized Muscat
Designer Quality Coin Charm Golden Nickel Free 9.5x7.5mm
Miyuki Seed Beads 11/0 Opaque Dark Cream
Stainless Steel Lobster Clasp Gold 12mm
Stainless Steel Chain Extension 47x3mm Golden
Stainless Steel Jumprings Gold 4mm
Stainless Steel Crimp Beads Golden 2mm
Nylon thread 0.3mm

Chain Necklace with Tila Beads:

Oval Chain Golden 11x4.5mm
Miyuki Tila 5x5mm Opaque Picasso Turquoise Blue
Miyuki Delica's 11/0 Fancy Lined Willow
Miyuki Seed Beads 11/0 Duracoat Galvanized Muscat
Miyuki Seed Beads 11/0 Opaque Dark Cream
Stainless Steel Lobster Clasp Gold 12mm
Stainless Steel Chain Extension 47x3mm Golden
Stainless Steel Jumprings Gold 4mm
Stainless Steel Crimp Beads Golden 2mm
Nylon thread 0.3mm

How t make:

Chain with Coin Charm

You start with 2 pieces of nylon thread of about 50cm. Attach those two pieces of nylon thread to a jumpring with a pinch bead. Then thread the pattern, and in the places where a coin is attached, put two beads that you thread at the same time on both the nylon threads. So the two pieces of nylon thread go through 1 bead at that point at the same time. When you have finished threading the pattern, attach the nylon thread to a jumpring with a pinch bead at the end as well. Attach another lobster clasp to one end, and an extension chain to the other. And then your necklace is finished.

Chain Chains with Tila Beads:

Cut two pieces of nylon wire of about 25cm. Attach the two pieces to 1 jumpring with a pinch bead. Thread the beading pattern and at the end also attach the two pieces of nylon wire again to 1 jumpring with a pinch bead. Cut two equal pieces of jasseron and fasten one piece on each side to the jumpring with the threading pattern attached. Then attach a lobster clasp to one end and an extension chain to one end. And then this necklace is finished!